Hello,
I discovered the pantone some time ago (2003) but without concretizing anything (lack of gear, not informed enough ...)
today, I'm looking to embark on the adventure of lower consumption and depollution.
I have a clio 1,9D obviously, renaults work in non-turbocharged so I think I'll try.
A question torments me about the power gain: I work today in the generator (Caterpillar from 13kVa to 2MVA it's beautiful engines) and I am therefore aware of the constraints surrounding them.
Today what I see is that we create a restriction on the exhaust and another on the intake: these constraints are according to my knowledge of the power losses (exhaust pressure and intake air restriction) do should we not increase the exhaust diameter behind the reactor? to compensate for his restriction?
do you put regulating valves on the 1/2 inlet which is free not to pass in the reactor? (if not the admission to the reactor will never be favored) (and what is the proportion of air flow to pass in the reactor).
Voila if the question has already been asked, please excuse me but it is still long to peel each post from forum (the site is great but it can be a little too much in every way)
Pantone lightening
-
- I discovered econologic
- posts: 1
- Registration: 02/04/07, 20:40
-
- Similar topics
- Replies
- views
- Last message
-
- 0 Replies
- 6987 views
-
Last message by Christophe
View the latest post
14/06/16, 23:04A subject posted in the forum : Water injection in heat engines: information and explanations
-
- 22 Replies
- 33447 views
-
Last message by Flytox
View the latest post
08/12/13, 11:57A subject posted in the forum : Water injection in heat engines: information and explanations
-
- 0 Replies
- 11772 views
-
Last message by carmelo42
View the latest post
03/05/13, 09:33A subject posted in the forum : Water injection in heat engines: information and explanations
-
- 13 Replies
- 29762 views
-
Last message by Flytox
View the latest post
22/03/16, 23:19A subject posted in the forum : Water injection in heat engines: information and explanations
-
- 5 Replies
- 19252 views
-
Last message by Flytox
View the latest post
24/10/12, 19:39A subject posted in the forum : Water injection in heat engines: information and explanations
Go back to "Water injection in heat engines: information and explanations"
Who is online ?
Users browsing this forum : No registered users and 84 guests