Search found 3 results
- 04/04/16, 12:43
- Forum : Hydraulic, wind, geothermal, marine energy, biogas ...
- Subject : Need help for Peltier modules
- answers: 31
- views: 22280
Re: Need help for Peltier modules
Izentrop I can tell you that these TEC-12706 modules hold the 200 ° without problem, provided they have good cooling. At this temperature I have never melted a module. On the other hand at 250 ° the margin is too low and I have already seen wires unsolder and fall by themselves. The lowest tem ...
- 01/04/16, 00:41
- Forum : Hydraulic, wind, geothermal, marine energy, biogas ...
- Subject : Need help for Peltier modules
- answers: 31
- views: 22280
Re: Need help for Peltier modules
the efficiency of a commercial peltier in seebeck mode (production of electricity) is at best 2% so to produce 100W you need about a thermal flow of 5000W. by working well the heat exchanges on a 15kw boiler, this is perhaps what we could recover: 100W No more ...
- 20/03/16, 00:23
- Forum : Hydraulic, wind, geothermal, marine energy, biogas ...
- Subject : Need help for Peltier modules
- answers: 31
- views: 22280
Re: Need help for Peltier modules
Hello everyone I am a largely beginner econologist however I have already worked a lot with peltiers and what I can advise is to integrate these modules as intermediaries and not as a finality. Let me explain: if you have a source of heat and you use it ...