Opinion and test Hydrogen HHO kit feedback experience?

[francklompa]

clement

http://www.panaceauniversity.org/Ravi%20Cell.pdf

doc in pdf which explains on cell of stanley meyer, its tubes, pwm box, faraday calculation etc ...

[Castex Clement]

Hello Francklompa,

Hey! yes we can no longer see the conference because it explained the operation and the concept of his cell and for good reason because Watterfuelducon grabbed it to sell with dollars his cells.

Quite simply.

[Castex Clement]

Bonjour David,

What consumption does not lower the water or the GO for the Go if you go too high in amperage the alterno will get full pot therefore engine braking = overconsumption
if 406 equipped with electronically managed lamda probe = + oxygen increasing GO flow rate all that does not lead to improvement.

[david97240]

actually the more gas I have the more I ride and this ke I gain c preske nothing

[francklompa]

yes 20 to 25amp is too much it will slow down the alternator! I pay it at 1oamp! David if you have lambda probe will need an efe box that controls this!

[francklompa]

CLEMENT
did you try to make the PWM stanley meyer?
The list of electronic components and printed circuit are on this pdf

http://www.panaceauniversity.org/Ravi%20Cell.pdf

[Castex Clement]

Franck,

yes i saw but no time for now i am on a cogeneration assembly

[david97240]

it is too hard to make I will try to take it on ebay.

[francklompa]

it's hard because we don't have the money and materials to make the electronic circuit!
in techno class we made a circuit on off 220v with micro sensor, a clap on, 2 clap off o :)))

after there are people who ask us to prove a drop in consumption o :)))) ahh lalaaa

better keep it to yourself lol

[Asl]

Hello everyone,

We too are currently in the process of integrating a PWM into our system.

And for all those who wish to buy a ready-made card, I would like to draw their attention to an important point: before buying it is compulsory to know which mosfet (s) equips your future card.

Because not all mosfets can operate on low voltage (14v battery).
One of the characteristics of a mosfet is the Rdson.
Let's simplify: it is the "resistance" (Oh! ) drain / source.

Example :
BUZ11: Rdson = 0,04ohm
The drain / source ddp, at 15A, will therefore be 0,6v.
But it is 0,6v which is "removed" from the voltage across your reactor, ie: 14v - 0,6v = 13,4v.
Production will necessarily be reduced.

So if it's an IRF630 ... Forget it right away!
Because Rdson = 0,4ohm!

@ ++