Hello
The starting already asked my network is one inch.
I read that depending on this diameter, the maximum possible flow is only 1,4 m3 / h.
What is the point of having a pump in 4 m3 / h?
This is the model that a pro me proposes (average HMT of 50-57 for a flow of 2,5 to 3m3 / h, and hmt max to zero m3 of 70)
The farthest point is about 100 m.
I evaluated my HMT 44 about but a little minimized the losses.
It turns out that 6 circuits are installed from the underground vault that contains the solenoid valves. they are all powered by the PER of an inch, but have bent reductions before entering the solenoid valves.
4 circuits start in one inch and two in 3 / 4 inch.
What do you think ?
PS
I almost went to a variable flow pump, but I am not sure of the ease of use and think that the cost involved is not negligible.
Pump selection and discharge diameter installed
-
- I discovered econologic
- posts: 2
- Registration: 22/04/14, 14:57
-
- Similar topics
- Replies
- views
- Last message
-
- 6 Replies
- 6855 views
-
Last message by Ahmed
View the latest post
14/08/22, 21:16A subject posted in the forum : Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ...
-
- 29 Replies
- 16335 views
-
Last message by oli 80
View the latest post
13/06/21, 11:11A subject posted in the forum : Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ...
-
- 35 Replies
- 26430 views
-
Last message by Grelinette
View the latest post
02/08/20, 15:40A subject posted in the forum : Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ...
-
- 24 Replies
- 37218 views
-
Last message by Christophe
View the latest post
26/10/21, 09:36A subject posted in the forum : Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ...
-
- 1 Replies
- 7560 views
-
Last message by Juju64
View the latest post
25/04/20, 17:11A subject posted in the forum : Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ...
Who is online ?
Users browsing this forum : No registered users and 109 guests