Hello everyone, I'm new to this. forum
by opening my idra 5000 pump to replace the capacitor
the wires got disconnected
does anyone have the wiring it would help
20221006_163719.jpg
cordially
Patrick
Guinard idra 5000 pump wiring
Re: guinard idra 5000 pump
Good evening Patrick41
I attach my proposal. Not very pretty, but enough talking I hope.
Good night.
I attach my proposal. Not very pretty, but enough talking I hope.
Good night.
0 x
Re: guinard idra 5000 pump
it is 230VAC.
given your plan... possible configuration:
- The brown phase goes to the float on the blue wire
- On the float the brown wire joins the thick black wire
- The end of the big black wire goes on the black motor wire
- The white wire from the motor goes to the Neutral of the power supply.
Now, as some colors are not identical, see if on the phase or neutral wire, there is not a security lying around (magnetic circuit breaker or other?
/PS: This is the same as the proposal for bmag1. To be tested if difference because the condo is probably on a secondary winding (?)
given your plan... possible configuration:
- The brown phase goes to the float on the blue wire
- On the float the brown wire joins the thick black wire
- The end of the big black wire goes on the black motor wire
- The white wire from the motor goes to the Neutral of the power supply.
Now, as some colors are not identical, see if on the phase or neutral wire, there is not a security lying around (magnetic circuit breaker or other?
/PS: This is the same as the proposal for bmag1. To be tested if difference because the condo is probably on a secondary winding (?)
0 x
Re: guinard idra 5000 pump
Good evening Gegyx and Bmag1
thank you for your quick response
by I think that Bma1 is right on its connection because it corresponds more to the male female plugs
20221006_163719.jpg
thank you for your quick response
by I think that Bma1 is right on its connection because it corresponds more to the male female plugs
20221006_163719.jpg
0 x
Re: guinard idra 5000 pump
For the float theoretically the wires are interchangeable
For the engine also, but a doubt for the internal connection of the engine (?). But if the plugs are interconnected it's all good.
And the big black wire, is it no longer useful?
For the engine also, but a doubt for the internal connection of the engine (?). But if the plugs are interconnected it's all good.
And the big black wire, is it no longer useful?
0 x
Re: Guinard idra 5000 pump wiring
20221006_163719.jpg
Good evening
thank you for the electrical connection of the pump
another small question when I opened the pump some oil leaked
can you tell me what oil and how much should i put
cordially
Patrick
20221006_163719.jpg
Good evening
thank you for the electrical connection of the pump
another small question when I opened the pump some oil leaked
can you tell me what oil and how much should i put
cordially
Patrick
20221006_163719.jpg
0 x
Re: Guinard idra 5000 pump wiring
Was it for sealing?
I couldn't tell you I only have surface pumps, without oil
I couldn't tell you I only have surface pumps, without oil
0 x
Re: Guinard idra 5000 pump wiring
Hello
little info for the amount of oil in the pump
the motor part must be filled with dielectric oil
and leave the part where the capacitor is empty
cordially
Patrick
little info for the amount of oil in the pump
the motor part must be filled with dielectric oil
and leave the part where the capacitor is empty
cordially
Patrick
0 x
Back to "failure, troubleshooting and repair: repair yourself? "
Who is online ?
Users browsing this forum : No registered users and 73 guests