tronxys x5sa pro 500 review: filament stuck in the extruder
published: 06/03/22, 15:58
Hello
I bought the tronxy x5sa 500 pro and the upgrade kit. I've read lots of good comments on it. Well after 2kg of melted filament I couldn't print anything. Why ? Because the extruders don't work properly. After a return trip of filament or even just a stop the filament is damaged and no longer goes up, the extruder blocks the filament. And I'm talking in one color, I can't even imagine two-tone.
No matter the settings through the software or the setting of the extruder wheel the result and the same.
Anyone got a solution?
Thank you
I bought the tronxy x5sa 500 pro and the upgrade kit. I've read lots of good comments on it. Well after 2kg of melted filament I couldn't print anything. Why ? Because the extruders don't work properly. After a return trip of filament or even just a stop the filament is damaged and no longer goes up, the extruder blocks the filament. And I'm talking in one color, I can't even imagine two-tone.
No matter the settings through the software or the setting of the extruder wheel the result and the same.
Anyone got a solution?
Thank you