3DRag untimely stops
published: 11/08/14, 17:54
Good morning all.
a problem with 3DRag. It stops after 10-20 minutes
On printing.
I changed the card, the drivers, the usb cable, the pc (windows Xp)
set the voltage to 0,43 v, power supply, install a fan ...
Nothing to do it stops.
The pc-card link works, the extruder and bed heating
works and the LEDs continue to flash.
Do you have any idea where this problem comes from?
With thanks
a problem with 3DRag. It stops after 10-20 minutes
On printing.
I changed the card, the drivers, the usb cable, the pc (windows Xp)
set the voltage to 0,43 v, power supply, install a fan ...
Nothing to do it stops.
The pc-card link works, the extruder and bed heating
works and the LEDs continue to flash.
Do you have any idea where this problem comes from?
With thanks