I will need to seal / repair an ABS part (no effort, just waterproofing but no pressure). Maximum dimension of the "holes" 2 cm approximately.
Which chemical shit can I use to make a lasting repair in ABS?
Resin for ABS, plastic part to be repaired
-
- Moderator
- posts: 79117
- Registration: 10/02/03, 14:06
- Location: Greenhouse planet
- x 10973
well either you "weld" with the soldering iron, it requires a little practice and a little ABS to melt on, otherwise it is a two-component epoxy glue.
in this style
in this style
0 x
"Thinking should not it be taught in school rather than to make learning by heart the facts that are not all proven?"
"It's not because they are likely to be wrong they are right!" (Coluche)
"It's not because they are likely to be wrong they are right!" (Coluche)
Back to "failure, troubleshooting and repair: repair yourself? "
Who is online ?
Users browsing this forum : No registered users and 126 guests