Hello,
I have an Ecoteck Monica 07 stove installed in 2009
For a week it has been working in degraded mode:
- On start-up it displays 'Waiting for flame', the fume extractor starts and the pellets fall regularly
- After 2 min (#20 pellets dropped) pellets stop falling, no change in display
- After 5 minutes, the display changes to 'flame present' and the pellets fall.
- then the stove goes into working mode
but:
- the pellets fall at the rate of 1 every 7,7 sec.
- the Air fan (it is operational) does not start
- the pellets run out quickly (a few minutes) and the stove goes into 'pellet exhausted' alarm then stops
- if I pre-filled the fireplace, it lasts a few tens of minutes
- during this period of operation I cannot act on the heating power (I go from level 1 to 5 without this having any impact) nor on the 'pellet-air mixture' program
Could a hardware element be involved (but why no alarm?) or a software element? (but how to return to factory settings?)
With thanks for your help
Jacks
Monica Ecoteck / Ravelli stove operation in very degraded mode
Re: Monica Ecoteck / Ravelli stove operation in very degraded mode
0 x
hmmmmm, hmmmmmmmmmmmmm, hhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhhmmmmmmmmm, huh, hmmmmmmmmmmmmm.
-
- Similar topics
- Replies
- views
- Last message
-
- 10 Replies
- 4978 views
-
Last message by sicetaitsimple
View the latest post
03/11/20, 20:03A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 6 Replies
- 12394 views
-
Last message by Philippe Schutt
View the latest post
03/07/16, 11:22A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 55 Replies
- 28402 views
-
Last message by Did67
View the latest post
27/01/14, 11:40A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 2 Replies
- 5397 views
-
Last message by jl9934s
View the latest post
09/12/13, 18:21A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 5 Replies
- 20583 views
-
Last message by manet42
View the latest post
29/03/10, 10:44A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
Back to "Heating, insulation, ventilation, VMC, cooling ..."
Who is online ?
Users browsing this forum : No registered users and 478 guests