Hello,
I am currently thinking of a self-built mass stove project.
So in fact, for a budget question it will not be a real mass stove, but just a wood stove surrounded by a large thermal mass.
So in the mass of the stove (approx 1,5m * 1,5m of surface) I would like to:
- create a room accessible by a well insulated door, in which there will be a cumulus of recovery of about 150L
- in this recovery tank, I remove the resistance and I replace it with a copper coil (so no need for electricity); I would actually like this balloon to be able to heat the sanitary water thanks to the copper coil which will be supplied on the one hand by a solar thermal panel (flow ensured by a solar pump) and on the other hand by a sensor (like Tickelmann mounting ) close to the wood stove (flow ensured by thermosiphon).
Can you tell me by looking at my block diagram if you think that this system is likely to work? In particular the thermosiphon flow which must go into the balloon and not into the pipes of the solar water heater (for that I put " U "to cut off the thermosiphon flow.
Also in the same mass stove I intend to preheat the air from a Canadian well in winter. The problem is that the pipe should also supply the stove with fresh air (so as not to take the one from the room). This principle poses a problem for me because I would be afraid of a reversal of the flow at the level of the air intake of the stove (that the air from the room of the stove leaves in the rooms); to counter this I thought to put a slightly more powerful fan upstream of the stove compared to that downstream.
the diagrams:
https://www.econologie.info/share/partag ... HgsLqk.doc
What do you think of the whole? you see prohibitive things there or on paper it would be theoretically possible?
Thank you very much for your contributions!
Vincent.
Multifunction mass stove
- antoinet111
- Grand Econologue
- posts: 874
- Registration: 19/02/06, 18:17
- Location: 29 - Landivisiau
- x 1
-
- Similar topics
- Replies
- views
- Last message
-
- 4 Replies
- 1961 views
-
Last message by phil59
View the latest post
05/12/22, 00:26A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 28 Replies
- 8154 views
-
Last message by Philippe Schutt
View the latest post
08/12/22, 09:28A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 1 Replies
- 3996 views
-
Last message by phil59
View the latest post
12/02/22, 21:08A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 15 Replies
- 9106 views
-
Last message by plasmanu
View the latest post
20/02/21, 08:31A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 1 Replies
- 7565 views
-
Last message by oli 80
View the latest post
19/12/20, 22:16A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
Back to "Heating, insulation, ventilation, VMC, cooling ..."
Who is online ?
Users browsing this forum : Yahoo [Bot] and 299 guests