Research equipment

[Lenonn]

Hi everybody.

I am a total beginner in experimentation.

I would like to make a "Brown's gas" torch first.
I went to the plumbing shops, I found the necessary to make the "reactor" but for the receptacles I did not find any (a plastic jar with a tight lid).
It's stupid, but impossible to get hold of it.
The system that allows the passage of gas through the cap is also difficult to have. I found some in compressed air systems but they are a little big and difficult to set up.
Do you have tips and tricks for that?
Thank you in advance.
cordially

[Bibiphoque]

Hello,
In microwelding, but it is overpriced in new equipment.

Or from a pressure stainless steel pan that must be filled almost to the top, you have to be a good handyman to create a safe system.
Beware, it’s far from innocent, the big boom! arrive faster than you'd expect!
@+

[the middle]

As said so well bibiphoque, be careful
Otherwise, a tank for peeing cars ... for scrap

[bobono]

This subject has already been dealt with on the site, there are even videos of the torch working on the site but I no longer know or leave your email in a private message and I will post it to you