Tractors doped water: a ok, ok and not a breakage
published: 27/02/08, 00:31
Good evening, I mounted two pantonned engines, the first to try 3 months ago on a 188 massey 70hp engine with a 21/16 outer tube reactor and a 14mm rod, this one "isolated" from the outer tube by a brass centering and bubbler heated by the exhaust gases with a temperature control thermometer, it works well and better and better (no black smoke, barely brown engine oil, fuel economy of 30% and gain in power)
On a 2nd renault 120hp tractor, I put 2 reactors on the same principle as previously with a separate bubbler heated by the coolant in slight contact with the exhaust t ° 65 ° C verdict a slight better in terms of smoke at exhaust but it consumes as much and no additional power, why? In addition, in 2005, I had already mounted a pantone quickly made with 7 reactors, it was working on fire, I had removed it because the bubbler was heated by the exhaust and the water boiled verdict with dead valves and 1 shirt out of 6 split + water in oil, at the time I had everything removed and thrown away. now I pay attention to the temperature of the bubbler. If you have a solution for the assembly think about telling it to me, I tried to do it at best
On a 2nd renault 120hp tractor, I put 2 reactors on the same principle as previously with a separate bubbler heated by the coolant in slight contact with the exhaust t ° 65 ° C verdict a slight better in terms of smoke at exhaust but it consumes as much and no additional power, why? In addition, in 2005, I had already mounted a pantone quickly made with 7 reactors, it was working on fire, I had removed it because the bubbler was heated by the exhaust and the water boiled verdict with dead valves and 1 shirt out of 6 split + water in oil, at the time I had everything removed and thrown away. now I pay attention to the temperature of the bubbler. If you have a solution for the assembly think about telling it to me, I tried to do it at best