first round pantone motor
first round pantone motor
hello everyone, I spent my week end to pofiner my mower engine that I ride in pantone, the hardest was to meet the neccessaire piece, but with a little patience c the engine runs. Of course, there was very little water in my bubbler but it works and it's fun. To all those who will try to launch you it works and it is not so hard to realize.par cons I wanted to put a video but it is 80 mo apparently do not go past 10 someone has the solution I do not know much about imformatique good thank you all and good luck.
0 x
I'm tired of paying too expensive gas and I've always dreamed of driving with water so that's where I'm going
https://www.econologie.com/fichiers/partager/gg.jpg
here is a photo c better than nothing
here is a photo c better than nothing
0 x
I'm tired of paying too expensive gas and I've always dreamed of driving with water so that's where I'm going
-
- Similar topics
- Replies
- views
- Last message
-
- 1 Replies
- 3691 views
-
Last message by Christophe
View the latest post
14/11/05, 23:48A subject posted in the forum : Water injection in engines: montages and experiments
-
- 0 Replies
- 4017 views
-
Last message by jpduval53
View the latest post
29/01/05, 12:25A subject posted in the forum : Water injection in engines: montages and experiments
Back to "Water injection in the engines: the assembly and experimentation"
Who is online ?
Users browsing this forum : No registered users and 138 guests