Hello,
Is it possible to make wind turbine blades with a router?
I was thinking of using small 10MM panels, then assembled.
What do you think ?
Thank you
Creation of wind turbine blades wood
Hello,
I will indeed also be interested to know if people have an experience feedback on this. I was planning to do pretty much the same thing but with a router, then finish with a sander.
In addition, I will say that a priori, airsp, it mainly depends on your ability to work with the machine. If you have a good mastery you should get there ...
A+
I will indeed also be interested to know if people have an experience feedback on this. I was planning to do pretty much the same thing but with a router, then finish with a sander.
In addition, I will say that a priori, airsp, it mainly depends on your ability to work with the machine. If you have a good mastery you should get there ...
A+
0 x
I think the first airplane propellers were originally made of wood. it will be necessary to find, or consult in an aeronautical museum for information, it must be found
see also a carpenter "work companion" he can give advice
good luck ... sharpen the wood chisel!
can be a site
www.helices-evra.com/
see also a carpenter "work companion" he can give advice
good luck ... sharpen the wood chisel!
can be a site
www.helices-evra.com/
0 x
every morning you look naked in a large ice after 3 minutes you will see that your home and your worst picture ......
-
- Similar topics
- Replies
- views
- Last message
-
- 0 Replies
- 3559 views
-
Last message by ludo76
View the latest post
01/03/10, 13:02A subject posted in the forum : Hydraulic, wind, geothermal, marine energy, biogas ...
-
- 42 Replies
- 32763 views
-
Last message by Ahmed
View the latest post
08/12/08, 20:40A subject posted in the forum : Hydraulic, wind, geothermal, marine energy, biogas ...
-
- 0 Replies
- 7200 views
-
Last message by 35flourish
View the latest post
15/05/08, 11:50A subject posted in the forum : Hydraulic, wind, geothermal, marine energy, biogas ...
-
- 29 Replies
- 24805 views
-
Last message by Yves Thomas
View the latest post
17/08/08, 16:56A subject posted in the forum : Hydraulic, wind, geothermal, marine energy, biogas ...
-
- 9 Replies
- 6006 views
-
Last message by neant
View the latest post
25/07/06, 18:26A subject posted in the forum : Hydraulic, wind, geothermal, marine energy, biogas ...
Back to "hydraulic, wind, geothermal, marine energy, biogas ..."
Who is online ?
Users browsing this forum : No registered users and 369 guests