I inquired about the exterior insulation, I would like to opt for this type of insulation, but I was told that we could see the location of the insulation panels on the plaster.
The insulation must stop at 15cm from the ground? Does this change the exterior appearance by creating an offset on the ground?
Outside insulation
-
- I discovered econologic
- posts: 9
- Registration: 08/11/09, 22:16
-
- Grand Econologue
- posts: 865
- Registration: 10/05/09, 16:39
- x 21
Re: Exterior insulation
killkiller wrote:I inquired about the exterior insulation, I would like to opt for this type of insulation, but I was told that we could see the location of the insulation panels on the plaster.
Never heard of it. In any case, it is clearly that the facade maker has a bad job. There are lots of achievements in France and especially abroad.
Killkiller wrote:The insulation must stop at 15cm from the ground? Does this change the exterior appearance by creating an offset on the ground?
No, on the contrary, the insulation must go down along the base wall to avoid a thermal bridge. This insulation must be done with a material that supports humidity, therefore PU, PSe or better cork (but €€€).
0 x
-
- Similar topics
- Replies
- views
- Last message
-
- 2 Replies
- 5064 views
-
Last message by Christophe
View the latest post
09/01/10, 11:42A subject posted in the forum : Hydraulic, wind, geothermal, marine energy, biogas ...
-
- 5 Replies
- 20502 views
-
Last message by casalanis
View the latest post
14/12/08, 11:59A subject posted in the forum : Hydraulic, wind, geothermal, marine energy, biogas ...
Back to "hydraulic, wind, geothermal, marine energy, biogas ..."
Who is online ?
Users browsing this forum : No registered users and 155 guests