Pellet / Idrofox code setup and start-up not ordered

Renewable energies except solar electric or thermal (seeforums dedicated below): wind turbines, energy from the sea, hydraulic and hydroelectricity, biomass, biogas, deep geothermal energy ...
graffiti
I discovered econologic
I discovered econologic
posts: 1
Registration: 05/09/08, 11:19

Pellet / Idrofox code setup and start-up not ordered




by graffiti » 05/09/08, 11:40

Hello, I have had an idrofox for a few months for which I am looking for the manufacturer code allowing to enter the setup.
thank you in advance.

point 2: the stove works perfectly. Out of season it is connected to the electrical circuit, but off for heating, weekly or daily programming on off. I noticed 2 times an untimely start-up and not requested / ordered from the idrofox !! not serious but surprising. I was thinking of radio interference, but the remote control is infrared. If you have an explanation, thank you in advance.
0 x

Back to "hydraulic, wind, geothermal, marine energy, biogas ..."

Who is online ?

Users browsing this forum : No registered users and 215 guests