Hello...
Problems with my pump ... After 4 months of inactivity, wanted to restart it but worries, does not start! The pump is not seized because the axis turns in both directions without the slightest problem. When I turn it on, no sound, the pump does not start. The 2 green diodes light up and after 2/5 seconds the red "fault" diode lights up.
Check the capacitor, no worries it works.
2 worries .... at the electric console, presence of water (!!! ???). Not up to the electrical plate, which explains, I think, that the pump does not cause the electrical panel to trip, but the presence of water in the engine.
Tried to see to dismantle the pump ..... Motor part, no worries, could unscrew not without difficulty the 4 screws. On the other hand, the 4 screws of the stainless steel block do not unscrew ......
they unscrew? a tip? Any idea why the pump doesn't start, even for 1 second ???
Thank you for your help
Surface pump (overpressure) Guinard25 4M
-
- Similar topics
- Replies
- views
- Last message
-
- 6 Replies
- 7143 views
-
Last message by Ahmed
View the latest post
14/08/22, 21:16A subject posted in the forum : Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ...
-
- 29 Replies
- 16889 views
-
Last message by oli 80
View the latest post
13/06/21, 11:11A subject posted in the forum : Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ...
-
- 35 Replies
- 27117 views
-
Last message by Grelinette
View the latest post
02/08/20, 15:40A subject posted in the forum : Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ...
-
- 24 Replies
- 37823 views
-
Last message by Christophe
View the latest post
26/10/21, 09:36A subject posted in the forum : Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ...
-
- 1 Replies
- 7772 views
-
Last message by Juju64
View the latest post
25/04/20, 17:11A subject posted in the forum : Water management, plumbing and sanitation. Pumping, drilling, filtration, wells, recovery ...
Who is online ?
Users browsing this forum : No registered users and 189 guests