Physical quantities of water and steam: T °, ​​p, HR, mass ...

Water injection in thermal engines and the famous "pantone engine". General informations. Press clippings and videos. Understanding and scientific explanations on the injection of water into engines: ideas for assemblies, studies, physico-chemical analyzes.
Christophe
Moderator
Moderator
posts: 79117
Registration: 10/02/03, 14:06
Location: Greenhouse planet
x 10972

Physical quantities of water and steam: T °, ​​p, HR, mass ...




by Christophe » 04/09/08, 15:26

If you are looking for a physical quantity of water (T °, pressure, density, specific heat ...) or water vapor, consult this link: http://www.thermexcel.com/french/tables/tables.htm

Under this heading you will find the following data tables:

Measurement units

* Tables converting the units of measurement: Length, Area, Volume, Mass and weight, Volume and mass equivalents for water at 15 ° C
* Tables of conversion measurement units: Equivalent flows - Speed ​​- Temperature - Force - Pressure - Energy (Joule, Kilocalorie) - Power - Viscosity.

Fluid mechanics

* Boiling water table at atmospheric pressure: Physical characteristics of the water: Density - Specific enthalpy - Mass and volume heat - Dynamic viscosity. (Please note the file is 90 kb)
* Boiling water table from 100 ° C to 200 ° C before vaporization: Vaporization pressure - Density - Specific enthalpy of water - Specific enthalpy of vapor - Mass and volume heat - Dynamic viscosity. (Attention, the file is: 100 ko)
* Boiling water table from 200 ° C to 300 ° C before vaporization: Vaporization pressure - Density - Specific enthalpy of water - Specific enthalpy of vapor - Mass and volume heat - Dynamic viscosity.
* Water vapor table from 0 to 30 bar: Vaporization temperature - Density and mass volume of steam - Specific enthalpy of water (Sensitive heat) - Specific enthalpy of vapor (Total heat) - Latent heat of vaporization - Specific heat of the vapor - Dynamic viscosity. (Attention, the file is: 100 ko)
* Water vapor table from 30 to 100 bar: Vaporization temperature - Density and mass volume of steam - Specific enthalpy of water (Sensitive heat) - Specific enthalpy of vapor (Total heat) - Latent heat of vaporization - Specific heat of the vapor - Dynamic viscosity. (Attention, the file is: 100 ko)

Psychrometry

* Dew temperature: Dew temperature of humid air below 1013 mbar.
* Wet temperature: Wet temperature (wet bulb) of the air below 1013 mbar.
* Density: Density of humid air under 1013 mbar.
* Enthalpy: Enthalpy of humid air below 1013 mbar.

Downloadable documents:

* Table of boiling water at atmospheric pressure
* Atmos water Table boiling water at atmospheric pressure
* Boiling water table from 100 ° C to 300 ° C before spraying * * Boiling water table boiling water before spraying
* Saturated steam table from 0 to 100 bar Steam Saturated steam table
* Dew point of humid air below 1013 mbar. T dew ° C Dew temperature of humid air
* Wet temperature (wet bulb) of the air below 1013 mbar T wet ° C Wet temperature, bulb
* Density of humid air under 1013 mbar Air mass * * Density of humid air
* Enthalpy of humid air below 1013 mbar
* Enthalpy humid air
0 x

Go back to "Water injection in heat engines: information and explanations"

Who is online ?

Users browsing this forum : No registered users and 119 guests