P170 (compensation?) It is on 1

Death of shame ...........! Of course, these are minutes .. It was late I think when I wrote the message.

Before pellets? I was heating with oil, a 25-year-old boiler with a damn regulation for the last 10 years and I was consuming 2500 liters. I specify that the whole house is heated to 20 °. There is no cool room. At night, it goes reduced (original time slots but I lowered the ° ...

Thank you to those who took their time to answer me. There is wonderful responsiveness on this site. I will continue to abuse your time since I still have questions: My installation has been started up, adjusted by the OKOFEN France technician (I don't know if this is the case ...

The compensation was original on 1. Should it be 1 or 0?

Apart from this bp that I mentioned, do you recommend it or not the room sensor? Because, for the rest, my heating works well.

I don't have a room sensor, no box in the house on which I can act. So to go up to 25, I go to the pelletronic menu, heating 1 (the radiators at home) or heating 2 (the heated floor). I have thermostatic valves, but they are all fully open.

I checked the compensation, it is on 1, I will maybe change it to 2? jean luc I thought my explanation was clear. . It was, but I like to be sure .... Too bad I have to wait for the next period or I will leave my house in frost free to check the quality ...

I understand that the boiler and the V3V react in this way during the 1st hour of heating, or even the 2nd, but what I'm talking about is 5h00 after turning on the boiler. At this time the boiler is fine ... there is 12 ° in the house, it is freezing and the radiators are only warm / ...

erreur

1/25 Only during the heavy heating phase. In cruising mode, as currently, I put 19, 5 and I have 21 in the radiators part. I made a modification today. I passed the water law from 1,0 to 0,8 for the radiators part. I left it at 1 in the heated floor part ...