Hello
I just looked, nothing to do always the same error message.
I do not think that it is the discharged batteries because it marks me 49,1 vlt.
I but some photo if its can help.
Thank you
Help for my solar battery installation
-
- Econologue expert
- posts: 13718
- Registration: 17/03/14, 23:42
- Location: picardie
- x 1525
- Contact :
Re: Help for my solar battery installation
You can have this voltage idle and a defective battery cell.Matenjo wrote:I do not think that it is the discharged batteries because it marks me 49,1 vlt.
Check that with a moderate load of 100 W for example, this voltage does not collapse, which would indicate an abnormal internal resistance of one of the batteries.
Towards the end of your leaflet http://www.mppsolar.com/manual/PIP-GK/P ... 190717.pdf, is noted that if permanent buzzer and permanent red light with displayed Fault code 08/09/53/57 = "Return to repair center."
Permanent buzzer or not?
I advise you to download this manual, instead of bombarding us with incomplete photos. (It unnecessarily eats server energy, even if Trump says it's clean coal)
Can be provided for a certain time by the batteries, in the manual is indicated 90 min with 100 Ah and 2500 VA battery, therefore 2000 W and cos phi of 0.8.Connect a "permanent" 2000W auxiliary to a 2000Wp PV installation
By counting the output it is better to table 75 Mn with a battery in condition.
Last edited by izentrop the 11 / 11 / 19, 09: 37, 1 edited once.
0 x
Re: Help for my solar battery installation
Hello izentrop
Yes permanent buzer.
And how should I proceed or do to verify that with a moderate load of 100w for example, that this voltage does not collapse?
Yes permanent buzer.
And how should I proceed or do to verify that with a moderate load of 100w for example, that this voltage does not collapse?
0 x
-
- Econologue expert
- posts: 13718
- Registration: 17/03/14, 23:42
- Location: picardie
- x 1525
- Contact :
Re: Help for my solar battery installation
First perform a reset to see if the fault is canceled.
0 x
Re: Help for my solar battery installation
I would like but I don't know how we do the rest?
How do I do this?
Thank you
How do I do this?
Thank you
0 x
-
- Econologue expert
- posts: 13718
- Registration: 17/03/14, 23:42
- Location: picardie
- x 1525
- Contact :
Re: Help for my solar battery installation
Ben turns off the inverter for 2 minutes and restarts, the fault should be canceled, otherwise it is really broken down, which would surprise me.
0 x
Re: Help for my solar battery installation
I just did nothing to do its the same
On the other hand the inverter marks me 900w and 20amp battery
Before I had never seen its marked !!!
On the other hand the inverter marks me 900w and 20amp battery
Before I had never seen its marked !!!
0 x
-
- Econologue expert
- posts: 9838
- Registration: 31/10/16, 18:51
- Location: Lower Normandy
- x 2673
Re: Help for my solar battery installation
Matenjo wrote:I just did nothing to do its the same
On the other hand the inverter marks me 900w and 20amp battery
Before I had never seen its marked !!!
Just to be sure, although this is certainly not the explanation for the non-restart, you checked that you had not "triggered" at the differential of what you call "AC-DC box" or arrival at your electrical panel?
0 x
Re: Help for my solar battery installation
Its there its fucked up I think, 800 ea the trash, what disgust ...
Engie asked me € 18000 to bring the network back to me, I think I should have made this choice, but hey I had no finances.
No sicetaitsimple it does not have that because I disconnected the two cables in 16mm2 which arrive at the box ac to be able to connect my group instead.
So inverter is connected only with batteries and panels.
I did not have much choice it is getting cold and my stove does not work current.
Engie asked me € 18000 to bring the network back to me, I think I should have made this choice, but hey I had no finances.
No sicetaitsimple it does not have that because I disconnected the two cables in 16mm2 which arrive at the box ac to be able to connect my group instead.
So inverter is connected only with batteries and panels.
I did not have much choice it is getting cold and my stove does not work current.
0 x
-
- Similar topics
- Replies
- views
- Last message
-
- 4 Replies
- 17001 views
-
Last message by darwenn
View the latest post
05/01/18, 14:32A subject posted in the forum : Renewable energy: solar power
-
- 26 Replies
- 14793 views
-
Last message by Obamot
View the latest post
02/05/16, 21:50A subject posted in the forum : Renewable energy: solar power
-
- 16 Replies
- 10941 views
-
Last message by titiyador
View the latest post
11/02/15, 17:55A subject posted in the forum : Renewable energy: solar power
-
- 2 Replies
- 5886 views
-
Last message by Ahmed
View the latest post
07/09/14, 18:26A subject posted in the forum : Renewable energy: solar power
-
- 58 Replies
- 31890 views
-
Last message by chatelot16
View the latest post
29/08/13, 22:18A subject posted in the forum : Renewable energy: solar power
Back to "Renewable energy: solar electricity"
Who is online ?
Users browsing this forum : No registered users and 113 guests