Does anyone have it, or is it possible to run the assembly above with oil? oil + water
Because it's the editing that I tried to do without result. Even when heating the oil has more than 100 degrees
If you want to operate a bulor with oil, it will have to heat it much more than 100c, rather close to 200c
whatever the liquid used in a bubbler you have to heat it close to its boiling point. for the oil has its point of illumination.
A mower with a panton works well with an oil blower, provided that you have an auxiliary heating to heat the oil, the heat of the exhaust is not sufficient to maintain an adequate temperature in the bubbler .
The engine runs without smoke the candle stays clean, you are limited on the power, unless you warm the oil to its point of inflammation with a blowtorch
(Watch out for burning oil from the bubbler air inlet tube, bend it down, especially when the engine stops.)
With experience you will realize that the engine consumes the volatile parts of the oil, in the end the engine has difficulty turning and there is a fat product in the bottom of the bubbler rather black caused significant heating. .
If you add water vapor in the same reactor you are limited to a small amount, under penalty of cooling the reactor.
(in my tests the vapor was produced by an adjustable ultrasound in flow)
.I wanted to check the hydrogen production of the process
Say that what comes out of the reactor is a gas with a very high hydrogen content? many say it, but I do not know how much we see, so what comes out of the reactor personally I do not know what it is, probably the same product that has entered but (refined) especially if we talk about doping a water, I would not be surprised that if we condense what comes out of the reactor, we give back water.
The reactor was directly screwed in place of the mower's exhaust pipe to heat it to at least 800 degrees
I have never measured more than 720c on a small motor even by forcing it, measured at thermocouple type K in a monel probe.
Andre