My little HYE600 wind turbine

[FRANCK (49)]

Domestic wind turbines: how the public authorities encourage a large swindle:
https://www.bastamag.net/Eoliennes-dome ... omment-les

2012

Today it does not sell much.
Intermediate batteries are needed for a small wind turbine like this. and it is clear that an inverter consumes empty, you must plan to cut it out of use.

On the inverter energies-renewable / configuration-and-a-Windmaster-500 de-mastervolt t11769.html

I'm trying to see that it only starts around 40vdc so that it actually produces as soon as it starts.

So you have this manual, I suppose? Programming http://neonext.fr/wp-content/uploads/20 ... EONEXT.pdf
On the regulator https://www.madep.com/cache/documents/c ... nne_77.pdf

yes I had the reprogramming notice
thank you

[FRANCK (49)]

Hello,

Can you say more about the installation?

The environment (rural, urban ... Altitude).

How high is the generator?

Is it on a mast (guyed how)? Fixed on a pinion?

... etc.

sorry for the delay
rural house
it is on the gable of an annex at 7m
no obstacles in the direction of the prevailing west wind (west to the right of the photo)
fixing cross the concrete block and large iron bars behind (no photos)

IMG_20191229_175012_resized_20200202_101913480.jpg (195.14 KB) Viewed 10220 times

my current config:

IMG_20191229_175012_resized_20200202_101913480.jpg (195.14 KB) Viewed 10220 times

therefore curve steep enough not to remain in "hooking" mode (starting phase of the soladin) which consumes instead of producing if the wind does not increase

[FRANCK (49)]

Intermediate batteries are needed for a small wind turbine like this. and it is clear that an inverter consumes empty, must plan to cut it out of use

I will test on batteries later

[FRANCK (49)]

So for 15 days I have produced 1.5kwh!
it is not much but it is a sastifaction I have always dreamed of having a wind turbine.

[FRANCK (49)]

Well, it's been a month since I have the cable and I am testing the curve.
8,8kwh production balance from January 18 to today
Well, there was Ciara Inès and Denis yesterday! It boosts the results
The wind turbine held up!
I often had 498w in max
I did not consume all of the 8,8kwh because there is already the inverter consumption which is not taken into account and when the power is greater than my consumption, which often happens even when it is well lose (this goes into the network)
.I put an even steeper curve especially for storms because it tended to get carried away during big gusts

[FRANCK (49)]

My latest values
Uo 10v = 0amp
U1 20v = 4a
U2 40v = 4a
U3 45v = 5.5a
U4 90v = 6.1

[A.D. 44]

Your feedback and your observations regarding your air generator are interesting.

Being absolutely not a connoisseur in the matter (although I try to document myself and get something out of it), I am following you carefully.

I will even be delighted to visit your installation ...

[oli 80]

Good evening, here is another type of wind turbines

installed on a weather vane

[Former Oceano]

I have the same wind turbine that was installed in 2012 on the back of my barn.
Having gone for a request to install a roof window at the urban planning office, I learned that an authorization was required as for an antenna and that the installer had not asked for it.

Okay, August 9, 2018, a tornado tore it away from me, so more wind turbines on the gable.

As I kept the debris I will see if I can reassemble it: I checked the body and the bearings they were not damaged, only 2 blades out of 5 and the cone of the nose exploded.

The balance sheet of the use is not flattering: Nuts of the fixing left at a time it leaned of traviolle. I had to climb on the roof, attach a blade to intervene, replace the nuts and screws left with others in stainless steel lined with self-locking nuts and with aluminum tape to secure everything.
When in production, it was modest, because since I put an old EDF type meter, it produced 141 KWh in 3 years and 3 months ... Basically 50 KWh per year ...

So I think in my case the gable pose was inappropriate. In addition it often turned quickly and I have the impression that the electric brake (injection by the controller of a high voltage to transform the generator into a motor to counter the wind and slow down the rotor) must have consumed a lot of current and s 'has been shown to be ineffective when the wind speed is too high.
On reflection I tell myself that 3 blades instead of 5 might have been more appropriate, or like on my farm pump wind turbine, a side arrow to remove the wind turbine from the wind bed when it is too strong to avoid use the greedy electric brake

As I have 3 blades left, I am thinking of building a three blade plate to fix on the old 5 blade to reassemble the rotor in 3 blades and put the wind turbine on a mast at the end of my property.

Here is the gear delivered without any doc, for the mastervolt I found the doc but not for the other the Wind Controler GC10-48WM.
In short if one of you has it in pdf (or can scan it to me) I will be eagerly interested.

[Fadelau]

Hello,
I have just recovered a wind turbine of the same type which works (namely that the inverters turn on in the event of wind) but I do not see any production via the linky meter. Being already a producer via solar panels, I should normally be able to watch this production. I have a 50V DC outage after the reol1K. Is this normal? Being on the 49, Franck 49 or another person will he have feedback?
Thank you in advance.