I finished editing my 3D K8200 printer : https://www.econologie.com/shop/impriman ... p-511.html
The computer and the printer communicate well but the XYZ engines work all 3 in the opposite direction, I checked my connections, they correspond to the assembly scheme. Anyone know which wires to reverse to keep the motors spinning in the right direction?
K8200: 3 of my engines run in the wrong direction
- beaverbranq
- I discovered econologic
- posts: 4
- Registration: 31/12/13, 09:46
- Location: Britain
- beaverbranq
- I discovered econologic
- posts: 4
- Registration: 31/12/13, 09:46
- Location: Britain
it depends if it is unipolar or bipolar motors, but from memory it seems to me that the principle is the same: it is necessary to reverse the order of the phases (as on a tri engine)
Basically connect A instead of B and vice versa.
http://fr.wikipedia.org/wiki/Moteur_pas_%C3%A0_pas
Basically connect A instead of B and vice versa.
http://fr.wikipedia.org/wiki/Moteur_pas_%C3%A0_pas
0 x
- beaverbranq
- I discovered econologic
- posts: 4
- Registration: 31/12/13, 09:46
- Location: Britain
reversing wires
Thank you Forhose!
I reversed two wires a bit random and it works, same thing for 2 other engines and everything rolls. I do not know much about motor. He takes out four sons, so two negatives and two positives .... chance may be a bit risky!
I reversed two wires a bit random and it works, same thing for 2 other engines and everything rolls. I do not know much about motor. He takes out four sons, so two negatives and two positives .... chance may be a bit risky!
0 x
-
- Similar topics
- Replies
- views
- Last message
-
- 9 Replies
- 21046 views
-
Last message by Christophe
View the latest post
06/10/15, 17:31A subject posted in the forum : 3D printers and 3D print: machines and technologies, hardware, software, use and optimization
-
- 23 Replies
- 42575 views
-
Last message by mopa8000
View the latest post
27/05/19, 00:07A subject posted in the forum : 3D printers and 3D print: machines and technologies, hardware, software, use and optimization
Who is online ?
Users browsing this forum : No registered users and 19 guests