Pantone for Peugeot 406 cut

[denis]

on my 2cv, I had made a tank system in the air, kind of watering rabbit

[Flytox]

hello, I redo my account pantone, I wanted to know if it is necessary to increase the section of the pipe at the reactor?

Which section are you talking about? You can not make a diagram please?

[Jean Valjean]

the party surround the picture, now is the 60,3 diameter ext ext spend a 76? because the reactor not bad mouth the passage of gas

[Jean Valjean]

oh yes I have seen them put misleading lambda, that do you think?

[Flytox]

the party surround the picture, now is the 60,3 diameter ext ext spend a 76? because the reactor not bad mouth the passage of gas

By changing to 76 mm, this allows you to recover the original passage section of the exhaust I suppose. It should not be larger than the origin in passage section, it drops the temperature for the reactor and in any case will not improve the agreement of the pot.

From what I could see on the net, for the Lamda probe, those who tamper with its information are most often more motivated by the search for power by "decalyzing" (or the economy of replacing the catalyst) rather than by seeking less pollution. André, you who use this lambda information, what do you do with it?

[Jean Valjean]

Hello, today I decided to redo my pantone entirely.
here is some photo

[Flytox]

Simple and effective and in stainless steel!

Have you welded the 2 ends (threaded rods) of the rod into the inlet and outlet elbows? There can be a big difference in temperature and therefore in expansion, between the reactor shell and the rod, possibly this can cause a lot of effort and cause a weld to crack. In my case, I only welded one end of the casing and the (removable) rod can move with a "soft" joint.

If you use non-demineralized water, (it's more effective according to some testers), limestone and other minerals end up clinging in the reactor and half-clogging it . It should therefore be possible to clean it in one way or another (removable rod, acid passage possible etc ...) after X km or month of use.
A+

[Jean Valjean]

I have quoted weld 2 because of the old mount the rod had to take the game and put a vibrate making a noise casserol.si ca ca casse risk what? to clean it if I put the AC acid should do ?

[Jean Valjean]

photo gvi


[Img]

[Flytox]

Hello jeanvaljean

I have quoted weld 2 because of the old mount the rod had to take the game and put a vibrate making a noise casserol.si ca ca casse risk what? to clean it if I put the AC acid should do ?

You do not risk much, noise or a small leak at most
For acid, stainless steel is good but the scrap surrounding the pot is not great. Above all, for the acid to go clean everywhere, it is necessary to handle the end of pipe, if it is 2 or 3 m long it is much less convenient ...