Water injection in engines: montages and experimentsGillier-Pantone on a Transporter T3

Edits and changes to engines, experiences, findings and ideas.
User avatar
manoria68
Éconologue good!
Éconologue good!
posts: 301
Registration: 07/10/08, 12:34
Location: ATLANTIS
x 1
Contact :

Unread Messageby manoria68 » 17/10/08, 20:03

still looking at the photos, I find that your welds do not air tight. especially in galvanized CONNECTIONS who should've been exposed before welding
I wonder if this is not also an element that discriminates your performance.
A well-made welding is watertight
0 x
Manoria 68, fried researcher, technician of its oil mill

jcf
I learn econologic
I learn econologic
posts: 40
Registration: 21/11/04, 22:58

Unread Messageby jcf » 26/10/08, 11:42

@manoria :
- for the size of my reactor I mainly followed the recommendations of André in the wiki and a priori it works well, so I have not much reason to change, except the diameter of the tube exhaust. But if I had to change the reactor, we have to redo everything, which is the same!
- Welds are actually very ugly, but all are waterproof. It was particularly hard to weld because the pot is aluminized, and so it crachouille in every way, even after having sanded elements, very great jigsaw feet. Where it is not waterproof, it is around copper pipes of GVI. We tried everything, even the oxy-acetylene, I do not know what to solder it! I was so clogged with all that dough to repair the exhaust, so it is tight but it farts after a moment;
- And in fact on your car, could you do the mods and quesque it gives?

@Flytox:
l'idée du tuyau en plus est rusée ! En fait le principal problème que j'ai est que le réacteur est trop avancé dans l'entrée même du tube, et qu'il n'y a pas moyen d'élargir le tube à cet endroit à cause de la bague mobile de fixation. C'est à cet endroit que la restriction doit être trop forte sur 5-7 cm. Ensuite j'avais prévu un diamètre du tube soudé en dessous (le noir) suffisamment grand pour que l'espace qu'ont les gaz pour s'échapper corresponde à l'espace qu'ils avaient dans le tube d'origine. Bon, à la soudure ça a pu un peu bouger, mais je ne pense pas que le problème vienne de là.
So what I thought trying to do is just open the black tube at its start (right in the photo you put here) and make the start as close to the moving fixing ring by opening the tube original much like a banana skin in order to get closer to the max with a minimum of seams. But it may be hot to do!

@ All: still no suggestion of industrial injector that would send water directly into the PMC instead of annoy with GVI?

Merci par avance pour vos suggestions !
JC
0 x
User avatar
manoria68
Éconologue good!
Éconologue good!
posts: 301
Registration: 07/10/08, 12:34
Location: ATLANTIS
x 1
Contact :

Unread Messageby manoria68 » 26/10/08, 19:50

OK understood !

J'ai créer un sujet pour mon montage https://www.econologie.com/forums/post101249.html

The first tests are very good, the doping, its march!
0 x
Manoria 68, fried researcher, technician of its oil mill




  • Similar topics
    Replies
    views
    Last message

Back to "Water injection in the engines: the assembly and experimentation"

Who is online ?

Users browsing this forum : No registered users and 3 guests