YOU could take my image and tell me where I should make the breather?

what diameter? 1 or 1.5 mm?

No not yet but it is planned, or so a breather, but I have not yet understood or pierce

Hello everyone, I haven't forgotten you. I advance quietly, in lost time. Here are pictures of my lamb: D: https://www.econologie.com/fichiers/partager3/1431462114dmkpMX.JPG https://www.econologie.com/fichiers/partager3/1431462161PDQrtU.JPG https: //www.econologie .com / files / share3 / 14314 ...

yes saw it from the nose, about 3m I would put pictures as soon as I have a little time to take care of this. My concern will rather be to size it small enough so that it operates as long as possible, at the end of the season the flow decreases and sometimes the source dries up. And who says little bel ...

I would say a good meter, suddenly if I do not have enough pressure, I could always raise the buffer tank higher.

I found in my brothel a piece of PE pipe of 7m, suddenly I will take this for my supply channel, if that is not enough I would change later.

Here is a diagram, does that seem correct to you?

yeah I saw that. Anyone have more info on fitting with a regulating chimney. In fact my source is already channeled higher in pvc, to the location of the future ram. there is a difference in altitude of 2/3 m seen from the nose. I said to myself when installing vertically a piece of pvc diameter 100 of a hectare ...

well actually i found in my brothel an old one kilo fire extinguisher.

Test at 26 bar. I am going to put inside a balloon bladder or an air tube inflated to 1 bar.

For my supply channel, PE or copper?

yes we need a ratio 6 and 8 I think, therefore 1 m elevation, 6 / 8 m long

yes I read all ca, ca must do, but after the info I've read right to left, the length of hose you also impacts performance.