Hello fools of Pellets,
Here I have acquired some time ago an okofen boiler which I assembled myself it works well I have optimize the heating curve so no problem on this side there.
But here I am trying to optimize my cycle time (apriori is better) for heating and two three things that bother me .... in order to reduce my consumption of pellets
Here is already my boiler stops at 74degres by the regul (gray time) p170 to zero. I read that it was necessary to put 170 to 1 so what stops by the boiler limit fix at 80 degrees is this better?!.
In addition I often have a pumping effect the boiler goes down below 61 degrees the v3v closes and the circulator stops. What looks like is not great.
Is it possible to give me a little summary of optimized boiler settings.
Thank you all for helping me.
Okofen Pes15 cycle time optimization
-
- Similar topics
- Replies
- views
- Last message
-
- 23 Replies
- 30195 views
-
Last message by foufbibi
View the latest post
07/11/11, 23:49A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 8 Replies
- 6720 views
-
Last message by swift2540
View the latest post
27/06/11, 18:55A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 24 Replies
- 82599 views
-
Last message by Obamot
View the latest post
27/12/12, 01:08A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 1 Replies
- 3226 views
-
Last message by loop
View the latest post
10/11/08, 12:23A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
-
- 4 Replies
- 12692 views
-
Last message by seb-19
View the latest post
07/03/08, 07:42A subject posted in the forum : Heating, insulation, ventilation, VMC, cooling ...
Back to "Heating, insulation, ventilation, VMC, cooling ..."
Who is online ?
Users browsing this forum : No registered users and 419 guests