oil boiler modified wood pellets: Ferroli kit

[1360]

Hello,

It's a shame, you need a password to see your blog.

A small question still: In the cover page it says:

Many people doubted this solution, undoubtedly "too simple", and the heating contractors took advantage of this doubt to try to sell me a complete system, much more expensive, by advancing such aberrant and contradictory arguments.

Can you tell me what those arguments, stp.

Thank you in advance and A +

[dirk pitt]

Bonjour à tous

By reading all the questions and comments on this forum, I allow myself to tell you that everything is described on this blog:

http://bruleurgranules.revolublog.com/

Photos, tips, documents, etc ...

Good installation !

it is however to make a blog with a password ... and make the pub here ????

[mroizo63]

Hello
We must seek access through the contact section leaving his phone number
cordially

[1360]

... Leaving her phone number

And bank details too?

;-)

[alex88]

Anyone know however is the u03 setting on a burner of a p7 I had to change the circuit board and from the boiler does not rise above the set and adjust 45degres has 70
please

[tangosierra]

Hello Alex88

u03 = "operating mode", see details on page 58 (9 ° page of pdf):
https://www.econologie.info/share/partag ... bNkXsl.pdf

The defaults for all other settings are also specified in this document.
A+
TS

[chris59]

Hello
Approximately one 5 years passed since the opening this post and I still have my P7 Sun this morning 6 time no heating, the electricity meter had tripped, I deliver the current, still no heating, LED lit boiler no liquid crystals on the Sun p7, of course red tempo.

After checking the fuse Sun HS, I replaced the fuse everything is working properly.

Is anyone has had this problem or what it is that EDF has trouble supplying us is that fucked up m ......

Thank you in advance

I do not not know if anyone ever wanted to send me a message, I had misconfigured oops my profile.

[TECHNO 45]

Greetings and best wishes to all.

Chris59 Hello, I am in the same position for two days, I checked everything and ended up changing the electronic box without more results ..
I did not know there was a fuse in the burner SUN P7, where is it you?
Thank you the information I could go see.
Kind regards.

[chris59]

Hello
Excuse me for the late reply
Look on the last page right instructions (Zoom), there is a 3.15 amp fuse that is just above the arrival of food (A, LN) a small gray tab to be learned

https://www.econologie.info/share/partag ... bNkXsl.pdf

Photo fuse

sun.jpg fuse (41.22 KB) Viewed times 5818

[skrink_skrink]

Qu vs wait for modular fashion? Is compatible with the control by dry contact 7-8?
Thank you and good appetite

Hello,
My viessman boiler looks identical to yours. Have you managed to fit a burner to Pellet?
If so, what are your recommendations?

cordially