I'm exposing my problem ...
So I have an Okofen Easypell pellet boiler. I tried to set it to have the desired temperature in the rooms of the house is 20 ° without having touched the thermostatic valves of the radiators.
Unfortunately, whatever the setting that I modify, while waiting well 24h after each modification, it is always the same report ... too hot in the house (Between 24 ° and 26 ° with the thermostatic valves opened at bottom).
For info, the values of the probes at the moment I speak to you:
- Outside temperature: 13.8 °
Boiler temperature: 71.8 °
DHW temperature: 58.2 °
Radiators temperature: 63.8 °
My current settings:
- Comfort environment temperature: 20 °
Reduced ambient temperature: 15 °
Slope: 0.1
Curve foot: 20 °
With these values, the hot water sent in the radiators is not far from 64 ° blow, it is the furnace in the house ... Even if I lower the temperature environment comfort to 10 °.
I feel that my settings are not taken into account .. The only thing that works is the temperature limit outside.
Even if I use the thermostatic valves to lower the temperature, I do not understand why it sends hot water despite my settings.
If any of you have a solution ...