Problem with my lathe

[boubka]

well, it looks like a simple contactor surely in series with the safety of the turn
so probably centrifugal contact ...

[marmotte38]

yes it is well connected to a security.
But before disassembling I would like to be sure that it is not the condo because it does not seem to me very fit

[boubka]

to test put an inter between v1 and z2, start your engine and open the inter or after 1 or 2 seconds.
if it works well then it is contact ...

[boubka]

then if it does not work you can measure with the ometer (naturally outside test) the continuity of the starting winding between v1 and v2
and the continuity of the permanent winding between u1 and u2.
if all that ok then hs condo

[marmotte38]

to test put an inter between v1 and z2, start your engine and open the inter or after 1 or 2 seconds.
if it works well then it is contact ...

but z2 is in the engine you didn't mean v2?

[boubka]

if after disassembly you see that the contact is really hs then the shunter and set a tempo outside, it works the same

[boubka]

but z2 is in the engine you didn't mean v2?

no you unplug v2 and you insert an inter serie.
so current wire in v2 on inter and inter output on v2

[marmotte38]

but z2 is in the engine you didn't mean v2?

no you unplug v2 and you insert an inter serie.
so current wire in v2 on inter and inter output on v2 [/ quote

it's good I did the test but it does exactly the same when I press the switch the engine starts but after a few seconds it trips
does that mean it's the condo then?

[boubka]

is good I did the test but it does exactly the same when I press the switch the engine starts but after a few seconds it trips
does that mean it's the condo then?

you have to start inter closed and then open it, apparently you do the opposite

[boubka]

the fact that the engine starts tries to prove that the condo is good ...